Remote tab

What it shows

When you select a serial connection in the tree view, this tab appears.

It allows you to specify special parameters for remote connections (modem or other scheduled connection):

In this group …	you must specify …
$images\ICO_PLCID.gif$ Handling of incoming calls	a PLC address where IGSS can read the logical node number of the PLC. This ensures that the data will be associated with the correct node number in IGSS.
$images\event.gif$ Indication of Successful Call Handling	a value at a specific PLC address where IGSS can indicate that all data has been successfully scanned (current and historical values). IGSS will disconnect once this value is written to the specified address.

How it looks

The figure below shows the Remote tab.

$images\com_remote.gif$