Create an analog template

In this example, we create a template, FLOWS, for a number of flow gauges. We will later create a new object based on that template.

Open the CONF table and insert a new record by clicking $images\ico_new.gif$ at the bottom of the screen.
Insert the following properties:

AREA = Global
ENAME = FLOWS
ETYPE = 33280

Fill in the remaining properties using the CONF table description.

$images\chiclet.gif$ Table description

Open the ATOM table and fill in the atom-specific properties, such as PLC address (data group, word offset and bit offset), I/O mode, etc.

$images\chiclet.gif$ Table description

$images\chiclet.gif$ Table description

If necessary, open the ANA_TEMPLATE table and define the alarm indication and acknowledgement bits.

$images\chiclet.gif$ Table description

Result: The analog template is now complete. You can now create a new analog object and base it on the template. Click the button below for details.

$images\btn_New_analog_object__58.gif$