To enable and use a simulation file

To enable and use a simulation file

When you want to use a simulation file, do the following:

Click here $images\SHORTCUT.gif$ to open System Configuration.
On the Data Collection tab, make sure that the Run Simulated box is checked.
Install the configuration.

$images\CHICLET.gif$ How?

Click here $images\SHORTCUT.gif$ to open IGSS Starter.
Click Supervise.

The values from the simulation file are now used in the configuration.

Note

If there are any syntax errors in your simulation file, these will be shown before the configuration is launched.

See Also Overview See Also See Also