Attaching a symbol to an IGSS object

Create the IGSS object

To create an IGSS object visualized with a symbol from the symbol file, choose one of the symbol tables in the lower part of the Objects menu.

The Object Browser appears allowing you to create the object types applicable to this symbol table. Select the object type and give the object a name and click Create.

Choose the symbol

The object properties dialog box appears. Click the Symbol Definition tab.

$images\Symedit_-_Symbol_Definition.gif$

At the bottom under Choose symbol, the symbol table selected in the Objects menu appears. Find the symbol in the browse pane and select it. Then choose the symbol color and adjust the other parameters, as required. Note that you can resize the symbol, if you enable the Make symbol scalable check box.

For a digital object, select the appropriate symbol and color for each state defined. All symbol properties can be saved in a template and then copied to the objects based on that template.

Place the symbol on the diagram

Finally, when you’ve clicked OK in the object properties dialog box, the symbol, object name and value/state can be placed freely on the diagram. In the figure below the object name (p2) and the symbol has been placed over the pipe.

$images\Symedit_-_Pumps_on_Refuse.gif$

Edit or create symbols directly from Symbol Definition tab

To edit a symbol, select it in the browse pane and click the Edit Symbol button. The Symbol Editor is activated and the selected symbol can be edited.

To create a new symbol, select the relevant symbol table and click the Edit Symbol button. The Symbol Editor is activated. Browse to the first unused symbol in the table – called “NoName” – and draw the symbol.